Recheck wheel-nut torque after a tyre change
换胎后复查轮毂螺母扭矩
Use the exact manufacturer torque after the vehicle has returned to the ground.
车辆落地后，按制造商准确扭矩复查轮毂螺母。
Careful beginner · 10 min · Calibrated torque wrench, socket
1. Find the exact specification
Use the owner manual or manufacturer service data for your exact wheel. Do not copy a generic internet torque.
查找准确规格
按车型与轮毂查车辆手册或制造商维修数据，不要照搬网络通用扭矩。
2. Set up on level ground
Vehicle fully on the ground, transmission in Park or gear and parking brake on. Inspect that each nut is present and seated correctly.
在平地准备
车辆完全落地，挂 P 挡或挡位并拉手刹；确认所有螺母齐全且正确贴合。
3. Tighten in a star sequence
Set the wrench once and tighten opposing nuts progressively until one clean click. Never add a pipe or keep pulling after the click.
按对角顺序紧固
设定一次扭矩，按对角顺序逐步紧到一次清晰响声；不要加套管，也不要响后继续用力。
4. Recheck at the specified distance
Follow the wheel or workshop instruction—often after a short bedding distance. Stop for vibration, clicking or any loose nut.
按规定里程复查
按轮毂或维修店要求在短距离磨合后复查；出现振动、咔嗒声或螺母松动立即停车。